LabVIEW drivers - Haake DC50 circulator

Haake DC 50

The goal of this vi is to visualize upto 4 hours of measurements on the external sensor of a Haake DC50 circulator using the RS232 interface and LabVIEW.

Connection

The Haake DC 50 is equipped with a 9 pin RS232 connector. A cable to connect the Haake DC 50 to a PC should have either a 9-pin or 25-pin female connector on the PC side and a 9-pin male connector on the circulator side. Using a 9-pin to 9-pin cable, the cable layout is as follows:

The interface parameters are set as follows (default setting):

Features

This version has the following features:

• starts measuring once opened
• collects one redout every 5 per seconds
• writes tab separated files using [date] [time] [readout] format
• updates (next) filenumber in .ini file
• stores name of operator in .ini file
• stores basic filename in .ini file
• shows data history of upto 10 hours

Remarks

You may start the vi by clicking on the icon on the desktop. It will run automatically once loaded.
You can start to store data by pressing the 'Write to disk' button. WARNING: You need the same button to close the file!

This vi uses the T3 command to read the external sensor. Use the T1 command to read the internal sensor.

Downloads

LabVIEW 6.1 / Windows 95

haake.vi
This vi can be used as a Haake DC50 datalogger.

haake-readout.vi
This sub vi reads one data point from the Haake DC50.

LabVIEW 7.0 / Windows 2000

haake.vi
This vi can be used as a Haake DC50 datalogger.

haake-readout.vi
This sub vi reads one data point from the Haake DC50.

Generic

haake.ini
Initialisation file.

See also

• Haake DC50 readout routine
• Haake DC50 manual pages